1. • CommentAuthoralan
   • CommentTimeMay 21st 2009

    permalink

   Hello everyone:
   I am a novice at this and I've looked through the documentation several times with no success. Can someone please tell me how to run a simple slideshow that starts with an image and runs until the final image and stays on the final image upon completion? I'd like for this to autorun and have no control button visible. Is this possible? Many thanks for any assistance you can offer. Regards

2. •  
     CommentAuthorchristophvl
   • CommentTimeMay 21st 2009

    permalink

   manual p13:
   onFinished “loop”, “loadNextAlbum”, “stop”, “showAlbumWindow” [loop]
   Determines what to do after an album has completed. “loop” tells the slideshow to play
   the album all over again. “loadNextAlbum” loads the next album and “stop” just lets the
   slideshow stop. To go to the album selection screen after all photos have been shown, use
   “showAlbumWindow”.

   So it is <code>onFinished="stop"</code>for you.
   Christoph

3. • CommentAuthoralan
   • CommentTimeMay 21st 2009

    permalink

   I have a little older version of the manual but found it. Many thanks for your assistance. I really appreciate your feedback! Regards

© 2009 Monokai, all rights reserved. Buy Monoslideshow.