1. • CommentAuthorjousch
   • CommentTimeMay 19th 2010 edited

    permalink

   I've buyed Monoslideshow 2,

   at first: the same problem could be reproduced in the demo. In the Preset "default" after activating Fulscreenbutton and fullScreenSacleMode=none works correct.NOW: If you switch to the Preset "RGB seperation" and also activate the "Fullscreen possibility" as I described, the Items (Images) always Scaling to Fullscreen.

   Is there a workaround for it?

   EDIT: The problem appear only, if "Ken Burns" is on. Is there a possibility for defining a maxheight and maxwidth in fullscreenmode for kenburns?

   thx in advance,
   jos

   ps: sry for my bad english...

2. •  
     CommentAuthorMonokai
   • CommentTimeJun 15th 2010

    permalink

   if you set Ken Burns, then internally the scaling is always set to 'scaleToFill'.

   creator of Monoslideshow
3. • CommentAuthorgrashalm4u
   • CommentTimeSep 19th 2010

    permalink

   hello monokai and all of you,

   i have bought monoslideshow as well. i would like to use kenburns mode "3D" or "3D backwards" combined with item scale mode= "scaleToFit" or "downscaleToFit".
   i found out that this would not work until i found your statement in the comment above.
   is there any way or possibility of combining those two items (kenburns mode and scale mode with "scaleToFit")? Because I have a lot of photos that are higher than wide.
   if all my photos were wider than high (in german: "querformat"), then i think i could use kenburnsmode without any problems. with kenburns mode the photos, who are higher than wide (in german: hochformat" are always cut in their hight, what, in fact, does not look very nice.

   so is there any possibility of combining these two items?

   if not, you maybe could add this feature in a next version?

   thanks a lot for answering,

   grashalm4u

© 2009 Monokai, all rights reserved. Buy Monoslideshow.